HJC黄金城

Displacement test bench for vertical and horizontal testing of workbenches controlled by load or load/position according to EN 527-3, 581-2-3, EN 1730, BIFMA X5.1. 4 test axes for horizontal bench testing and 1 test axis for vertical bench testing. Each test axis has its own controllers assembled nearby, which are operated from a PC via the CAN bus and work synchronously. They are powered via a central power supply terminal that can carry up to 5 pneumatic test axes. The central supply terminal and PC can be placed on separate frames. Via the USB interface on the PC, data, control commands and software settings are transferred to the pneumatic test axis via the central power terminal. Part of the test bench is our extensive testing and evalsuation software for system software Windows 2000, XP or Win7.

Included

• box frame 2.5 x 2.5m, ca. 2m high, made from 80x80 R&K light weight profiles, screwed and stiffened on the corners with gusset plates

• 4 vertical and 1 horizontal profiles as crosshead for taking the cylinder, crosshead easily relocatable because of roll guides

• In the box frame there are 2 stiffened strips of the base plates, relocatable

• 4 pneumatic test axes for horizontal table testing, load controlled, piston diameter 50mm, stroke 300mm, load up to 1500N, load cell 5kN

• 1 pneumatic test axis for vertical table testing, load controlled, piston diameter 80mm, stroke 500mm, load up to 2500N, load cell 5kN; fixed on the extension; laterally relocatable, installed below the traverse member

• 5 load cells 5kN integrated in the axes

• Operating pressure and cylinder limit switch control

• 1 emergency stop button on each test axis • Number of cycles and course of load to be set arbitrarily in the PC software

• 4 load pad round, fixed 50mm

• 1 load pad round, diameter 100mm, gimbal clamp

• Fasteners for tables