HJC黄金城

Deflectograph measures the transient deflection of the road surface under the action of a rolling wheel at standard loading conditions to assess the structural condition of pavements.

Deflectograph data is used together with a well established design procedure to estimate structural residual lives and where necessary to design overlay thicknesses to extend the structural life.

Deflectograph is ideal for regular network deflection surveys and has a daily survey capacity of 15 to 20 kilometres, with an operating speed of 2.5 km/hr..

The Deflectograph is an automated deflection measuring system based on the Deflection Beam principle.

Deflection measurements are taken in both wheelpaths using two deflection beams, mounted on a common reference frame resting on the road surface.

The deflection beams and reference frame are stationary during the deflection measurement cycle and remain stationary until the maximum deflection has been recorded.

The reference frame is then pulled forward at twice the vehicle speed by a clutch and winch system to the initial position for the next measurement cycle. With the reference frame again at rest, the measurement cycle is repeated.

This method of operation gives measurements of deflection in both wheelpaths at about 4 metre intervals. To travel between measurement sites, the Deflectograph measuring frame can now be picked up hydraulically, to ease the burden on operator and driver.

The deflection data recorded in both wheeltracks is stored on USB flash drives.  The operator controls the survey and adds locations reference markers to the data during the survey and also records pavement temperatures at regular intervals.

The Deflectograph is calibrated before each days testing and processing is undertaken using a suite of computer programs. The deflection data recorded by the Deflectograph are temperature corrected and used, together with information defining pavement construction and commercial vehicle traffic flows, to estimate structural residual lives.

The temperature corrected deflection data are also used to design overlays of different thickness to extend the structural life of a pavement.

WDM? manufacture the British version of the Deflectograph, which is a fully self-contained, vehicle mounted system of standard configuration, consisting of a deflection measuring assembly and data recording electronics. Standard rear axle loading (6 – 10 tonne) is achieved using ballast fitted to the vehicle chassis.